Accurate Ovulation Prediction: Luteinizing Hormone (LH) Rapid Test Kit-Factory Direct & Wholesale. Custom OEM/ODM Solutions.
What is Luteinizing Hormone test cassette designed for? Ovulation is the release of an egg from the ovary. The egg then passes into the fallopian tube where it is ready to be fertilized. In order for pregnancy to occur, the egg must be fertilized by sperm within 24 hours after its release. Immediately prior to ovulation, the body produces a large amount of luteinizing hormone (LH) which triggers the release of a ripened egg from the ovary. This “LH surge” usually takes place in the middle of the menstrual cycle.
Luteinizing Hormone (LH) Rapid Test Kit
|
The LH Ovulation Test Kit (Urine) is a complete system to help predict the time of ovulation, and peak fertility. It is during this fertile time that pregnancy is most likely to occur.
The LH One Step Ovulation Test Device (Urine) detects the LH surge in urine, signaling that ovulation is likely to occur in the next 24-36 hours. The test utilizes a combination of antibodies including a monoclonal LH antibody to selectively detect elevated levels of LH. Important: The LH surge and ovulation may not occur in all cycles.
Bulk Ovulation Tests is for monitoring ovulation and guiding conception. During a woman's menstrual cycle, there is a sharp increase in LH peak before ovulation, known as the "LH peak". This peak will trigger ovulation in the ovaries within approximately 24-48 hours. The LH peak may be very brief, usually lasting only 48-72 hours. If the testing is not frequent (such as every few days), it is easy to miss this peak.
|
POSITIVE: Two lines are visible and the line in test line region (T) is the same as or darker than the line in the control line region (C). This indicates probable ovulation in 24-36 hours.
NEGATIVE: Two lines are visible, but the line in the test line region (T) is lighter than the line in the control line region (C), or there is no line in the test line region (T). This indicates that no LH surge has been detected.
INVALID: Control line fails to appear. Insufficient specimen volume or incorrect procedural techniques are the most likely reasons for control line failure. Review the procedure and repeat the test with a new test. If the problem persists, discontinue using the test kit immediately and contact your local distributor.
Post time: 2025-10-23 14:52:03
.png)
.png)
.png)
Privacy settings